Hello all,

New to the Carver world and this forum, but not new to the boating world. We just picked up our 93 Carver 300 Sedan near the beginning of August and are loving it so far! But as with any boat of this age, there's always work to be done...

Which brings me to the task at hand... rebedding.

There were low to moderate amounts of moisture/delamination found during the survey in the typical areas near the bow pulpit, handrail stanchions, etc.. I've recently begun the process of rebedding said items just this past weekend. I did the starboard side handrails this past Saturday, and all went quite well.

The question I have for the experts here is regarding the bow pulpit, which I intend to do on my next trip to the marina. So my question is this: does one need to completely remove the bow pulpit and rebed underneath, or does everyone just usually rebed the hardware? I'm not exactly sure how the pulpit is attached besides the four carriage bolts thru the anchor locker and the handrail stanchions. Said another way, does Carver put sealant underneath the entire pulpit during assembly? From what I can tell just by looking at it, it appears that it's just bolted down and there's a bead of caulk/sealant around the edge of the pulpit. It's obvious none of these items have ever been rebedded until now, so however it left the factory is how it will be when I undergo this project. While it's not leaking at the pulpit, yet, I have had some minor water intrusion from the starboard handrail stanchions, hence why I've taken on this project. Just want to make sure I do this right the first time.

I appreciate any input you guys/gals may have. I've already learned a lot from lurking around this forum!

-Kenny