Carver Owners Forum

I'm looking into sprucing up the dashboard on my boat. I'm looking at the Sierra Lido series gauges. I priced out all the gauges and it would be a little under $600, and that seems too cheap and easy. Is there any reason these wouldn't just be a simple swap?

Example:

https://www.overtons.com/sierra-lido-6- ... lsrc=aw.ds

Greetings All!

I'm one week into owning my first boat, a super clean 1983 Riviera with crusader 220's (1600/1200 hrs). The previous owner took amazing care of this boat. It's first 20 years were spent on Lake Michigan and the last 20 years were spent on the St. Croix river in MN/WI, where it will remain for many years to come. I'm happy to be here!

I have a 1995 325 aft cabin with twin Crusader 350XL motors. The port side muffle is cracked and leaking. I searched the Owners manual and can’t find the part number or any reference to it. It looks like a Centek 1600507? The intake and outlet are 5”. Anyone know where I might find the part number and supplier?

Thanks…

I have a 2006 Carver Motoryacht. It is a model 466. My question, what is the difference between the model 46 and the model 466?

I have read a fair amount about the line from the toilet to the black tank becoming permeated and causing an undesirable odor. I can see also that replacing that line is a solution for said odor. That however, appears to be easier said than done on my '86 Mariner 3297. Has anyone had success with other solutions?

Looking for the filter numbers for both the small and larger spin on filters for my Volvo TAMD 74. Not at the boat and need to order them. Thanks!

Hi all
I looked at a 1994 voyager 370 with Cummins boat is not bad but when I looked at the service possibilities for the engines I couldn’t figure out how to gain good access. Do u have to remove the kitchen and the whole table assembly for routine maintenance? Is it generally difficult to have good engine access in this model? Your expertise would be greatly appreciated. Thx

Hi all!
Ok, so I'm heading back down to the lake this weekend and wanted to order replacement LED equivalent bulbs for both navigation lights as well as the stern transom light. They all, at least appear to be, original to the boat.
Any help on the bulb size/style would be super helpful prior to me leaving so that I can order them asap.
Thanks in advance!

I have a 3297 and the central bilge, just fore of the potable water pump, is always wet. The pump float engages when there is more than an 1 1/2" or so, but always leaves that behind. Manually engaging the float purges most of the water, but some water is released back into the bilge when the pump switch is released. Occasional manual mopping of the remainder is tedious. Any solutions?

Has anyone sourced a suitable replacement for the sliding door for the cubby compartments?

PXL_20230709_072108779.jpg

Welcome to Carver Yachts Owners Forum

View the latest post Attachment(s) Carver 2807 Gauges Upgrade

View the latest post Attachment(s) 1983 Carver 2807 Aft Cabin Riviera

View the latest post 1995 325 Muffler blown

View the latest post Attachment(s) Model difference?

View the latest post Cabin odor

View the latest post Volvo Fuel Filters

View the latest post Voyager 370

View the latest post -1987 Carver 4207 Navigation light bulb size (LED)?

View the latest post Mid-ship bilge pump

View the latest post Attachment(s) Replacement sliding door for cubby