Carver Owners Forum

Original faucets from my 1994 390CPMY needed replacement. Easier to remove the cabinet doors, use the hatch from under the dinette (saved my back!) and removed old faucets. OF course, hole was 1/8” too small, so had to go easy and cut it larger. OF course again, the fittings needed adaptors, Nothing at Home Depot, Lowes had a pair after an hour looking. Nice neat installation if I say so myself!

hi everyone, I'm fixing another person's "diy special" I have an 89 santego 2767, spend last year rebuilding carbs, new water pump and impellers, tune up fresh oil, plugs cap...the works!! I'm a pretty handy girl :blush:

but my next fix is the shifters. They are pretty much garbage, bought a used (mid 90's) set of mercruiser shifters and thought because they were hard to shift driving past year I'd just replace the cables as I suspect they are the issue.
Does anyone know a part # or length of what I'd need? Thought I'd order before I start pulling old ones.
Any advice?

Thanks
Deanna

Hello from Toronto Ontario Canada!
Hoping to learn lots from everyone here :-)

Found the ventilation possibilties a bit minimal for our boat. And there was some dripping here and there when the winds are strong. In the past the windows had leaked considerably, judging from the traces and damage.

Thought I had to replace the narrow brushes in the frame as some are all but gone.

Had a closer look at the windows today and found out that there is a bottom part caulked where I think is not a logical place.

Are the rear windows supposed to slide forward? The middle windows slide to the back at the moment.

1621798577925.jpg

Any information welcome.

Has anyone modified their front windshield to add a vent in the lower part for better air flow?
Thanks,
Walter

Hello,

I was on plane across the lake yesterday at 3900 rpm. Engine temp, oil pressure everything normal but suddenly both engines dropped down to 3200 rpm and no matter how high my throttle setting, they remained at 3200 rpm... seems some sort of protection kicked in... any idea? I do have half a tank of old fuel mixed with new fuel in both tanks

Thanks

I am ready to part with my original convertible table from my 390. It is heavy and it is in good condition and functions perfectly. ANY idea of where I should be at an asking price before I post it in various places? Will need to be picked up as very heavy.

Thank you!

Tony

I have a 1994 model 370 with twin crusaders.

Dumb question, but how does one remove the engines to service them? Even if one could get a hoist into the salon, It doesn't look like there is enough clearance to take them out of the main hatch.

OK, so stupid question. I just purchased a propane grill (Kuuma). Instead of using the small screw on tanks, can I just purchase a propane grill set up with regulator from Home Depot and use that? I should know this but.. :beergood:

Looking for some help in replacing my existing garmin system with newer equipment. Have 1040sx and wanting to swap to (2) 1712's (have the equipment) . Located in Hampton. VA. anyone know anyone in the area?

Welcome to Carver Yachts Owners Forum

View the latest post Attachment(s) Kitchen Faucet Replacement

View the latest post Throttle cables for 89 2767 Santego

View the latest post Hello from a new member

View the latest post Attachment(s) 1992 280 sedan window question

View the latest post Front windshield Vent for 2004 466 Aft Cabin

View the latest post Sudden limit to 3200 rpm

View the latest post Attachment(s) Table from my 390CPMY

View the latest post Attachment(s) Voyager 370 engine removal?

View the latest post Gas Grill

View the latest post Garmin/electronics tech Tidewater area