I need to replace a section of the rubber and metal rub rail on my starboard side. I called TACO but apparently they didn't supply CARVER with rub rails. I'd like to get the same brand as what Carver installed but I'm finding it challenging to find an exact match. Any help is greatly appreciated!

i have a 1994 250 express and i am missing the actual latch that keeps the doors from flapping when they r shut. i have tried carver, south co who made the part and ugly fish who they referred me to and still cant find part. does anyone have a pic or info on an actual part number for this item. i have the lock at the top just missing the latch.

Hi does anyone know the size of the flax packing needed for a 1991 carver 3608 im not with my boat at the moment and I wanted to order some off the net. Thanks lee

Hi,
I have a 89 carver there is a vent valve in line with the hose going in to the holding tank looks like 1/1/4 or 1/1/2 it looks like a tee in line now it's leaking when I flush the head does anybody know where I might get one I tried all the places I know of
Thanks
Gary

Where can you get plumbing photos or drawings for a 2001 Carver 444 CPMY?

Hi all I have an 88 Carver 3257 that I bought last September and after quite a bit of work, just about have it ready to live on. There is still 1 leak in the hosing/pipe from the water connection at the front of the starboard engine going back to the toilet. There is no way to get to it from the engine side and I'm trying to figure out the easiest way to access the hoses as they run from the engine hatch to the forward head.

The only real access seems to be under the dinette seat to the right of the stairs coming in to the cabin, which would require removing the seat to be able to get to the hoses. Is there an easier way?

I'd appreciate any advice from anyone who's done this kind of thing.

Thanks so much

Needed to add a cook top exhaust blower without tapping into the cabinet space above. Off the shelf versions would not work due to dimensions and location of exhaust ports so I came up with this.

I have four ac units aboard my 450 Voyager. Two are located port side in salon, guest quarters unit is under berth, master's cabin is behind the bulkhead, under the pilothouse. How do I access this master's cabin unit? Seats in the pilothouse are not easily removed, nor is the cabinetry. What am I missing here?

Appreciate the help,

Jerry

Hi there. Have a 1986 32 Aft cabin with 305 Crusaders. Have owned boat for three years and we love it! It was very well maintained and upgraded by prior owners.

We have added about 100 hours in the last 3 years. However, due to busy schedules, we used it very little in the past six months. My port engine started developing a ton of moisture inside the distributor cap. Replaced it (including new seal), added Wire dry/WD40, and it ran fine. Yet after a few weeks pulled the cap and was completely corroded. Again cleaned it, added wire dry/wd-40; Ran for a bit and died. Cap was full of moisture.

Ideas???

Never had a problem until recently.
Anyone using vented caps and if so, where can I get them? Thinking of venting the cap to a vacuum in the carburetor.

HELP!!!!!

I have a 98 Carver 350 Mariner and I am looking for a place to purchase the front Sunpad. Any ideas?