Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

  • Global announcements
No global announcements

  • Latest Posts

View the latest post Generator


Kohler model 7.5, R27. Ran fine. Just shut down like it was turned off. Found blown cranking relay fuse. Replace fuse (3 times). Nothing. Now does not blow fuse, but nothing at either test position, or remote. Battery good. New solenoid.
Any ideas???

Views: 93  •  Comments: 6  •  Write comments

View the latest post Shower Faucet


I have a 2002 410 Sport Sedan. The faucet in the Master Shower is leaking from the base. I have taken the faucet apart from the top and replaced the O Rings on the valves but it hasn't fixed the leak. The water shoots out between the base of the faucet and the counter top. I can't take the faucet out because its completely sealed within the counter top and there is no access underneath it? I would literally have to remove the entire top which is sealed and glued to the base. Does any body have a similar design and have any advice on how I can replace this faucet?

Views: 53  •  Comments: 2  •  Write comments [ Read all ]

View the latest post fender cleat


i have a 2008 Carver Mariner. there are 2 fender cleats at the steps going up. one of them broke but cannot figure out how to attach a new one. cannot get to it through the engine room. thoughts?

Views: 75  •  Comments: 2  •  Write comments

View the latest post Wanted: Carver 4207 - Great Lakes area


Looking to buy a Carver 4207 (1986 - 1991) that is located within the Great Lakes.

Very motivated for this particular model, and ready to get to a quick close to enjoy the boat for the balance of the season with my family.

Thanks,
John

Views: 61  •  Comments: 1  •  Write comments

View the latest post Streaming Netflix Tip


I busted our gig allotment for our LTE internet on the boat last month mainly due to Netflix with the grandson on board. Turns out you can change the parameters of the quality you want to receive which greatly reduces the amount of data used. I was at the best quality setting which can eat up to 7 gig/hour on full 4k. Lowered this down to the lowest setting which will only allow .3 gig/hour. On smaller TVs this is very acceptable video quality. Simply log into your account via computer or phone where this can be changed in the Account/Choose a profile/Playback settings. Will need to revert back once at home cause it will look like crap on an 80" screen. :-D

Views: 60  •  Comments: 0  •  Write comments [ Read all ]

View the latest post 370 voyager fresh water pump location?


I think that my 12-volt fresh water pump crapped out. Where on board would one typically find it installed on a 370 voyager?

Views: 77  •  Comments: 3  •  Write comments

View the latest post Main breaker tripping


Hi, I just bought a Mariner 420 2004. The shore power cable is a 50amp 125v/250v cable. When I took possession of the boat it came with a 30amp 125v to 50amp 125.250v pigtail. With this cable everything on the boat is working fine. I can power shore 1 and shore 2 with it. Although we are tight on power when the 3 air conditioning systems are on and drawing power.

I bought a Reverse Y cable 2x30amp (shore side) to 1x50amp (boat side) - model marineco RY504-2-30. When I use this cable the main breaker on the boat trips immediately.

Any idea on why this would happen?

Thanks in advance for your help :)

Laurent

Views: 133  •  Comments: 6  •  Write comments [ Read all ]

View the latest post Trent Severn


Probably heading up the Trent around mid August. Anything I should now regarding covid or low water conditions or anything out of the ordinary. It will be the just my wife and I and we both have had both shots over 14 days ago. I have already made this trip once before so I do know a little of what to expect although this time we will be taking our time doing the Trent. Probably a week up, 2 weeks++ on Georgian Bay and a week back.

Views: 96  •  Comments: 2  •  Write comments

View the latest post Attachment(s) '92 Carver 350 Aft Cabin Enclosures -Aft Deck & Bridge less Bimini


For Sale: Complete aft deck enclosure (not wing door version) with hanging tracks and screens, and complete bridge enclosure NOT INCLUDING BIMINI AND FRAME. Original factory installation.

Panels are generally in good condition, except some minor repairs needed. Usable as is. Stitching and fabric appear good, plastic reasonably clear, two plastic pieces need replacement. No mold or mildew. Color: black

Currently stored flat and cloth-interleaved.

Located at USA Marina, Stony Point NY. Pickup only, not able to ship. Available for inspection any time.

Price $650. Reason for selling: prefer the open.

Please email for photos

Phil Little
414-630-2153
plittle2005@yahoo.com

Views: 92  •  Comments: 2  •  Write comments [ Read all ]

View the latest post Carver Riviera 1989 - Original Aft Cabin Railing size, 7/8?


90 minutes away from the marina and I need to order stainless steel fitting for a project. I'm not sure if the original rail in the back of my Carver Riviera 1989 is 7/8" or 1". Anyone knows this detail or has access to a Riviera easily?

309

Views: 61  •  Comments: 0  •  Write comments




  •  Who is online?

  •  Newest members


  •  Statistics
  • Totals
    Total posts 47768
    Total topics 5644
    Total Announcements: 0
    Total Stickies: 4
    Total Attachments: 3802

    Topics per day: 2
    Posts per day: 15
    Users per day: 3
    Topics per user: 1
    Posts per user: 6
    Posts per topic: 8

    Total members 7779
    Our newest member jeffnnoble

  •  Birthdays
  • No birthdays today
    In the next 30 days
    No members have a birthday within this period of time.

  •  Sponsors