So I don't have to go the lake and look, would anyone have the model type or manual for a Norcold refrigerator that came installed in a 1991 Carver 3607 Aft Cabin? I need to replace the freezer door to be specific. Thanks for any help

Hello all, I have a 59’ 2008 Carver Marquis. It has a GOST high water alarm, cameras and security. I can not find the main control panel for the system. I talked to a Representative from GOST and he told me, every technician puts them in different places. If anyone has suggestions, please help. I’ve looked under cushions in the salon, under the helm, engine room, closets, etc. thanks

I wasn't sure the best place to post this on the forums but I had to share. How big is the dash on a 360 Sport Sedan? Large enough for a 6' 4" (2m) man to fit inside.

Hi all, considering buying a 1997 Carver 500 with the Cummins 8.3's... Hope you can give me some advice? What material are the fuel and water tanks in this model? With 1000hrs, (1000hr service done) along with after coolers serviced, what should I be concerned with? Had numerous boats, just never a Carver. Thanks in advance.

Hi all,
I'm 2000 miles away from the boat - I need to order full new seals - tubes, everything!

I have a copy of the build sheets and I have 2-1/4 shafts. However I don't have the stern tube size.

Can anyone advise - do you know the stern tube size, or do you know the tides kit part number?

Thanks In advance for help.

Does anyone know the best way in going about the removal of carpet
on my walls?

Kindly,
v/r,
Stephen

Hello friends,

It’s been awhile since I’ve posted…I’ve been working on my vessel. My God, it’s slow going and expensive.

In the salon area, I’ve been taking the wall panels off and I’m getting those covered in black leather.

I was thinking while those panels are off, does it make sense to add some spray foam insulation?

This is my first boat - and criticisms are welcome..I have a thick skin.


Kindly,
v/r,
Stephen

Hello! I purchased a 2002 Carver 346 last summer and am looking to make a few updates for the 2026 season.

Would be nice to know the position of the trim tabs vs. just pressing the dash toggle UP or DOWN not knowing when the tabs hit their stops (as I dont have a dash gauge). Currently I just keep pressing the button and holding for a while assuming eventually I will be all the way up (or down), not sure if that does any harm to the hydraulics either.

Does anyone know what brand Carver used and if they have any sort of a position wire that might work with a trim tab gauge that I can still purchase? There are some outboard 2" gauges that look at resistance and then of course there is an entire new setup with hydraulics, wiring, UP DOWN buttons and a gauge.

My tabs still work fine so just looking to install a compatible indicator on my dash.

Hi team,

I'm redoing the electrical system on my Carver 3607, and frankly, it's a mess. I need to change the chargers, and I'm not sure how to redo the distribution panels without tearing everything out. It’s honestly more complicated than optimizing the latency in an online game at least there, if you mess up your settings, you don't risk a fire! Has anyone here done this before? Any tips and tricks to avoid burning the boat or breaking the bank on reliable equipment?

Thanks, guys.

Hi team,

John here, JJ312 on the forum. I just bought an '88 Carver 3607. It needs quite a bit of work, especially the electrical system, as you saw in my other post. I'm in the southwest with the boat.
Looking forward to exchanging tips with you!