Welcome to Carver Yachts Owners Forum
We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com
You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
Spring Launch - AutoPilot and Navigation/Anchor lights Dont Work
Spring Launch - AutoPilot and Navigation/Anchor lights Dont Work
I launched today and all systems go, except my autopilot wont power up and my Navi/Anchor lights wonts either.
I suspect it has something to do with the 12V DC Breaker Box on the bridge. That is where both of those units run through. I have checked the circuit breakers to assure they are one, and they are. So, just wondering if I am missing something obvious (Wouldn't be the first time). All the other circuits that run through that breaker box seem to be functioning (radar, deck lights, etc, etc).
They did some electrical work on the boat over the winter, adding a few AC plug receptacles, but I don't see how that would relate.
Any thoughts or checks would be appreciated.
Thanks
Rich
-
- CYO Supporter
- Posts: 2290
- Joined: March 28th, 2016, 10:52 pm
- Vessel Info: 1998 Carver 355
Suspicious Fishes !
2022 Kawasaki 310X - Location: upper chesapeake bay
- Has thanked: 313 times
- Been thanked: 581 times
Re: Spring Launch - AutoPilot and Navigation/Anchor lights Dont Work
I would start with a volt meter and check the output of the breakers. Then the nav light switch and if good 12v, check at the bulb mount at the lights. Maybe just a bit of corrosion, it happens.
Also, if any of your ac work was on the bridge maybe you accidently disconnected a ground wire somewhere?
Re: Spring Launch - AutoPilot and Navigation/Anchor lights Dont Work
Thanks for your input on this, was helpful. I found the culprit on the auto pilot. Once I was able to get behind the instruments (which I actually learned Carver makes it pretty easy to get to by removing the bridge seat backing), it appeared that during the plug installation this winter, the tech pulled out the connector on the auto pilot. Simple fix.
Nav lights fixed to.
Thanks again for your thoughts.
Regards,
Rich
Return to “Electronics & Navigation”
Who is online
Users browsing this forum: No registered users and 19 guests