Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

2004 360 Sport Sedan questions

The is the forum to discuss general information regarding all Carver Yachts.
User avatar

Topic author United States of America
bowfirer
Scurvy Dog
Scurvy Dog
Posts: 3
Joined: February 1st, 2021, 7:35 pm
Vessel Info: 2004 Sport Sedan, Volvo engines (gas)
Location: Long Beach, CA

2004 360 Sport Sedan questions

Postby bowfirer » February 1st, 2021, 7:55 pm

Greetings all! I'm a newbie Carver owner with a couple of questions I'm sure someone out there can answer.
1. I have a circular gauge on the electrical panel that shows the fresh water amount. However, I've yet to find a gauge of any kind that shows what the level of fill is for the BLACK water tank. I realize I probably could go crawling around below deck and look for the tank but seems to me there should be a gauge somewhere. Ideas?
2. I recently (I've only had the boat a little over a month) ran into an issue with the motor stalling as we were trying to enter a slip, very dodgy moment. So, I brought in a well-recommended mechanic to try to suss out the continuous problem with getting the engines running and keeping them running. The mechanic was perplexed by the boat shuddering when we tried to start the engines (Volvo Pentas). He developed a theory that there might be excessive back pressure due to the underwater exhaust arrangement. Any ideas on this?
OK, there will be more questions coming as I get more up close and personal with this gorgeous vessel, so, I thank any respondent in advance
Cheers!
Patrick


United States of America
tomschauer
CYO Supporter
CYO Supporter
Posts: 2291
Joined: March 28th, 2016, 10:52 pm
Vessel Info: 1998 Carver 355
Suspicious Fishes !
2022 Kawasaki 310X
Location: upper chesapeake bay
Has thanked: 314 times
Been thanked: 583 times

Re: 2004 360 Sport Sedan questions

Postby tomschauer » February 1st, 2021, 8:14 pm

It has nothing to do with the underwater exhaust. Find a new mechanic.
If they are gas engines, most likely time for a tune up.
What engines and how many hours?
User avatar

Canada
pepmyster
Admiral
Admiral
Posts: 975
Joined: June 5th, 2018, 7:17 am
Vessel Info: 2004 Carver 360 Sport Sedan
8.1 Volvo Penta
Fresh water boating
Location: Ottawa
Has thanked: 442 times
Been thanked: 191 times

Re: 2004 360 Sport Sedan questions

Postby pepmyster » February 2nd, 2021, 6:01 am

Good day! Have the same boat. Believing that you have 8.1 VP gas? If so, the stalling is very common. The ISC , Idle Servo Control) valve on the the throttle body could go bad, causing stalling when idling or going trying to start. Very common.
User avatar

United States of America
buster53
Admiral
Admiral
Posts: 995
Joined: May 12th, 2017, 10:41 am
Vessel Info: 2001, Carver 356
Location: Lower Potomac, VA
Has thanked: 8 times
Been thanked: 254 times

Re: 2004 360 Sport Sedan questions

Postby buster53 » February 2nd, 2021, 8:20 am

As far as your holding tank goes, on my 2001, 356, I have a small panel right next to the head with 4 indicator lights on it, green, yellow, orange and red. Green is empty, red is full. Sure you don’t have one as well?

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 5810
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 432 times
Been thanked: 1588 times

Re: 2004 360 Sport Sedan questions

Postby Viper » February 2nd, 2021, 8:29 am

I agree with the guys. Could be the IAC or IACV (idle air control valve), or they may just need tune ups. If the boat is new to you and you don't know when an ignition tune up was last done, that's where I would start. And if you don't know when the impellers were changed, I strongly recommend replacing those too. As Tom mentioned, post the engine model you have, if you have a serial, post that too as that will indicate the actual build.

Have you tried looking in the head for the black water gauge? Look in cabinets, behind curtains, etc. You may instead have an electronic indicator somewhere with LEDs instead of a gauge. I suspect you have a Vacuflush head? If so, check the control switch if you have one beside the head and look for any hint that it may indicate levels too.
User avatar

United States of America
buster53
Admiral
Admiral
Posts: 995
Joined: May 12th, 2017, 10:41 am
Vessel Info: 2001, Carver 356
Location: Lower Potomac, VA
Has thanked: 8 times
Been thanked: 254 times

Re: 2004 360 Sport Sedan questions

Postby buster53 » February 2nd, 2021, 2:24 pm

When I bought my 356, it came with Crusader 8.1's. The IAC on the port engine was making a lot of noise and my surveyor said it needed to be replaced. It was replaced and no problems since.
User avatar

United States of America
tjh408
Scurvy Dog
Scurvy Dog
Posts: 46
Joined: August 15th, 2019, 10:24 pm
Vessel Info: 2003 Carver 360 Sport Sedan
Location: Mystic
Has thanked: 18 times
Been thanked: 9 times

Re: 2004 360 Sport Sedan questions

Postby tjh408 » February 2nd, 2021, 3:14 pm

The tank is between the engines. The indicator lights on my 2003 360 are in the cabinet opposite the head where the TP is. I would also suggest a tune up. There isn't much to do, plugs, perhaps wires and inspection. It will depend on the hours?
User avatar

United States of America
boatdave
Scurvy Dog
Scurvy Dog
Posts: 12
Joined: June 22nd, 2015, 2:33 pm
Vessel Info: Currently looking for 396 Carver
Location: St. Louis
Has thanked: 6 times
Been thanked: 3 times

Re: 2004 360 Sport Sedan questions

Postby boatdave » March 8th, 2021, 2:56 pm

Your stalling could also be a common VP problem of the paint flaking off the inside of the fuel pump and clogging the filter. No clue why they ever painted it. As I found out its not impossible to back into a covered slip on one engine..... And the above is correct for your black water tank monitor. On the right side of the cabinet where your TP is. I just sold my 2005 360 so feel free to contact me with any questions sir.
User avatar

Topic author United States of America
bowfirer
Scurvy Dog
Scurvy Dog
Posts: 3
Joined: February 1st, 2021, 7:35 pm
Vessel Info: 2004 Sport Sedan, Volvo engines (gas)
Location: Long Beach, CA

Re: 2004 360 Sport Sedan questions

Postby bowfirer » April 29th, 2021, 3:11 am

Just went through the stalling issue with the port engine as we were lining up with the slip. Oh, just great! Anyway, turns out the batteries were shot and the alternator could not keep up with the electrical demand. Replaced the batteries; all fixed. This is a 2005 Carver 360 Sport Sedan. One other thing: if you want to replace the shore power cables be prepared to spend some $$$. Carver, in their infinite marine wisdom, decided to hard wire the original cable to the midship panel. Yes, really, they did. So, I had to buy two 100 ft 30 amp cables and have my electrician cut them and install a couple of sockets in the transom (just like almost every other boat) so I could disconnect them prior to setting out on a trip (just like other boats). Other than that, she's a beauty!
User avatar

United States of America
tjh408
Scurvy Dog
Scurvy Dog
Posts: 46
Joined: August 15th, 2019, 10:24 pm
Vessel Info: 2003 Carver 360 Sport Sedan
Location: Mystic
Has thanked: 18 times
Been thanked: 9 times

Re: 2004 360 Sport Sedan questions

Postby tjh408 » April 29th, 2021, 8:02 am

The indicator for the black water tank is in the cabinet where the TP is opposite from the toilet. open the doors and look to the right.

Return to “Carver Yachts Forum - Model Discussion”



Who is online

Users browsing this forum: No registered users and 46 guests