Welcome to Carver Yachts Owners Forum
We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com
You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
Carver 355/356 Aft
- bud37
- Admiral
- Posts: 5017
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 589 times
- Been thanked: 1253 times
Carver 355/356 Aft
We would appreciate some likes and dislikes from present or past owners of this model. Maybe some tips on what/where to look for issues, I have seen a few, with one in particular I have checked out fairly closely.
I have not seen one on the hard yet....do they have a keel at all ?

-
- CYO Supporter
- Posts: 6102
- Joined: July 10th, 2015, 9:58 pm
- Vessel Info: 1989 Carver 3807 Aft Cabin
- Location: Ontario, Canada
- Has thanked: 461 times
- Been thanked: 1721 times
Re: Carver 355/356 Aft
Other than that, it's the usual soft spots and high moisture reading areas that you would find on a lot of other models and brands of that vintage.
Where are the ones you've been looking at?
-
- CYO Supporter
- Posts: 2319
- Joined: March 28th, 2016, 10:52 pm
- Vessel Info: 1998 Carver 355
Suspicious Fishes !
2022 Kawasaki 310X - Location: upper chesapeake bay
- Has thanked: 326 times
- Been thanked: 597 times
Re: Carver 355/356 Aft
As Viper mentioned, the aft tanks were problematic. Our boat had the aft tank replaced by the original owner when it was just over three years old, just out of warranty, and back then a 5k bill. If you are looking at any of these and they have no fuel in the aft tank, its most likely bad. Not an issue if you do not do a lot of long-range cruising as you have two other 110 gallon tanks.
- Carverlvr2
- First Mate
- Posts: 112
- Joined: September 15th, 2024, 10:13 pm
- Vessel Info: 2004 Carver 366, VP 8.1’s
1992 Carver 33, Crusader 7.4’s
1979 Searay Sundancer 260 - Location: Shelbyville, IL
- Been thanked: 16 times
Re: Carver 355/356 Aft
- bud37
- Admiral
- Posts: 5017
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 589 times
- Been thanked: 1253 times
Re: Carver 355/356 Aft
This was a real nice boat though, couple little things not deal killers ( macerator toilets, shower sumps need cleaning bad, hot water tank fittings leak and a big one, some oil under both engines) recent oil change ????......should have seen the pos we checked out earlier in the day, needed a gas mask to board...


Viper, we missed one of the earlier 33 afts with diesels up your way, maybe you know that one.

- buster53
- Admiral
- Posts: 1056
- Joined: May 12th, 2017, 10:41 am
- Vessel Info: 2001, Carver 356
- Location: Lower Potomac, VA
- Has thanked: 9 times
- Been thanked: 264 times
Re: Carver 355/356 Aft
Haven’t had issues with my aft tank. If we take a trip, I like to use the aft tank to get there and the saddle tanks to come home.
LOVE my 8.1 Crusaders that the PO repowered with. Easily cruise at 20-21 mph and with a clean bottom, can hit 35.
Any specific questions, let me know.
- Cooler
- Admiral
- Posts: 1668
- Joined: May 22nd, 2018, 12:09 pm
- Vessel Info: 1995 Carver 330 Mariner
Twin 350XL Crusaders
Home port: Menominee, MI - Location: Green Bay, WI
- Has thanked: 68 times
- Been thanked: 400 times
Re: Carver 355/356 Aft

( All weather people have to say this on air, near lakes )
- buster53
- Admiral
- Posts: 1056
- Joined: May 12th, 2017, 10:41 am
- Vessel Info: 2001, Carver 356
- Location: Lower Potomac, VA
- Has thanked: 9 times
- Been thanked: 264 times
Re: Carver 355/356 Aft
bud37 wrote:Source of the post So we are considering a late 90's 355/356 aft.....crusader gassers. We do like this model's size.
We would appreciate some likes and dislikes from present or past owners of this model. Maybe some tips on what/where to look for issues, I have seen a few, with one in particular I have checked out fairly closely.
I have not seen one on the hard yet....do they have a keel at all ?
Bud, where are you located?
- bud37
- Admiral
- Posts: 5017
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 589 times
- Been thanked: 1253 times
Re: Carver 355/356 Aft

Southern Ontario... Heh buster does this boat have a keel or just flat aft section.

- buster53
- Admiral
- Posts: 1056
- Joined: May 12th, 2017, 10:41 am
- Vessel Info: 2001, Carver 356
- Location: Lower Potomac, VA
- Has thanked: 9 times
- Been thanked: 264 times
Re: Carver 355/356 Aft
bud37 wrote:Source of the post Thanks for the responses guys.....![]()
Southern Ontario... Heh buster does this boat have a keel or just flat aft section.
Pretty sure it is fairly flat. I’m going to the boat tomorrow and it was supposed to be hauled today for bottom cleaning and paint. If I get a chance, I’ll take a picture and send it to you. Any other photo shots you want to see while out of the water?
Return to “Carver Yachts Forum - Model Discussion”
Who is online
Users browsing this forum: No registered users and 14 guests