Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

1997 Crusader 454XL raw water pump leak

GAS engine, transmission and generator repair and maintenance discussion forum.
User avatar

Topic author United States of America
tgmkwill
Scurvy Dog
Scurvy Dog
Posts: 26
Joined: July 6th, 2018, 3:20 am
Vessel Info: 1997 355 Carver Aft
Location: Chesapeake City
Has thanked: 1 time
Been thanked: 3 times

1997 Crusader 454XL raw water pump leak

Postby tgmkwill » July 24th, 2023, 12:40 pm

Impeller and wear plate was just replaced on engine.

Water sprays enough from the small "retaining screw cam" that I could tell from looking at diagrams. It is a single flathead screw near the raw water intake hose clamp area.

Water dibbles out of even with engine off and seacock open.

Engine running, raw water starts to spray and drip faster. Enough to accumulate about a gallon of raw water in the bilge directly under pump/pulley area. After 1 hour run in the bilge under engine (not enough to flow through the next limber hole into the overall bile area). No temp issue or water pump alarm. Water does spray on other parts, pulleys etc. while engine is running at higher rpms, so of course this unwanted.

Any ideas from best case to worst case scenario before checking into this?

I attached pics of similar water pump (not exactly like mine) but that #6 retaining cam screw is universal on a lot of the raw water pump diagrams i could find, and that is where the leak is.

Thanks !
You do not have the required permissions to view the files attached to this post.

User avatar

United States of America
g36
Admiral
Admiral
Posts: 1944
Joined: April 7th, 2014, 6:07 pm
Vessel Info: 1997 Carver 405
Location: Soddy Daisy TN.
Has thanked: 7 times
Been thanked: 587 times

Re: 1997 Crusader 454XL raw water pump leak

Postby g36 » July 24th, 2023, 1:19 pm

Does it tighten anymore or stripped threads? If the threads are in good shape why not try some permetex / silicone sealant near the screw head on the threads and re install it again.
1997 Carver 405
Crusader xli
The Black Pearl
Soddy Daisy Tn.
User avatar

United States of America
km1125
Admiral
Admiral
Posts: 3348
Joined: February 28th, 2017, 6:04 pm
Has thanked: 59 times
Been thanked: 970 times

Re: 1997 Crusader 454XL raw water pump leak

Postby km1125 » July 24th, 2023, 1:29 pm

Yea, like g36 says... if the screw can be tightened on the cam then just put some thread sealant on the screw before putting it in and tightening it down. You probably don't even have to disassemble the pump, just pull the screw out, clean things, put sealant on there and tighten back down. Loctite makes a thread sealant but any permatex or silicone or similar will do the job. Heck you could put 5200 on but you might never get the screw out again!! :)

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 5810
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 432 times
Been thanked: 1588 times

Re: 1997 Crusader 454XL raw water pump leak

Postby Viper » July 24th, 2023, 8:16 pm

Ya it's not a biggie here and the solution can be what has been suggested above but if it won't tighten because it's stripped, then you need to remedy that as I'm sure it holds the cam in place and you don't want to take shortcuts here if that's the case. Hopefully it wasn't over-tightened and stripped the cam.
User avatar

Topic author United States of America
tgmkwill
Scurvy Dog
Scurvy Dog
Posts: 26
Joined: July 6th, 2018, 3:20 am
Vessel Info: 1997 355 Carver Aft
Location: Chesapeake City
Has thanked: 1 time
Been thanked: 3 times

Re: 1997 Crusader 454XL raw water pump leak

Postby tgmkwill » July 26th, 2023, 12:44 pm

Thanks for all advice !

Return to “Gas Engines/Transmissions”



Who is online

Users browsing this forum: No registered users and 16 guests