Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

Cat, Cum, or Vol ....

DIESEL engine, transmission and generator repair and maintenance discussion forum.
User avatar

United States of America
tonyiiiafl
CYO Supporter
CYO Supporter
Posts: 887
Joined: November 19th, 2015, 4:00 am
Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
Location: Cape Cod, MA
Has thanked: 588 times
Been thanked: 175 times

Re: Cat, Cum, or Vol ....

Postby tonyiiiafl » November 23rd, 2016, 5:48 am

CATS have a set maintenance schedule , period. They have a "recommended" rebuild time in hours rather than a take on oil analysis and then a call. Low hour oil and fluid changes, they get their colon in a knot if you don't use their filters and in my instance make it almost impossible to honor a warranty. As for Hats and Viking, they are using their engines in their "low end" builds. most Hats and Vikings have Mann's. I have been there and will again, say "CATS are useless". I had a chance to have purchased my current 94 with Cats, but choose the gassers instead. Again, just an opinion, from a diesel mechanic, who has been there and never wants to go back again.


Canada
Viper
CYO Supporter
CYO Supporter
Posts: 5803
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 431 times
Been thanked: 1586 times

Re: Cat, Cum, or Vol ....

Postby Viper » November 23rd, 2016, 7:16 am

Points taken Tony but I think you can say most of the above about every brand. In my experience, I can't say that any one brand has a worse failure rate than the others. The only mysterious catastrophic failure I've run into was on a Yanmar, still left wondering about that one. As for regular maintenance, it depends on what we're talking about. I wouldn't count fluid changes for example but mechanical adjustments or major component changes are a different story and I'm not talking about the regular peripherals like impellers, belts, filters, etc. Let's face it, every brand has it's pros and cons, none are a perfect build mechanically. One must also consider price points, are there better, of course, but one must weigh everything when considering dishing out extra cash for pricier brands going into a boat. The market dictates that one. I guess it hinges on one's tolerance level when it comes to maintenance and past experiences dealing with repairs and the OEM for comebacks and warranties. I liken it to sterndrives; none are a perfect build as they all have pros and cons. The best drive would be a combination of all the pros in each brand. While that would be the best drive, I suspect there are those that would still take issue with some aspect of the design based on their own experiences. Personally I think CATS are work horses. Do I wish some changes were made? of course, but we can say that about every brand.
User avatar

Canada
Midnightsun
CYO Supporter
CYO Supporter
Posts: 2838
Joined: March 27th, 2016, 2:27 pm
Vessel Info: The Midnight Sun
2007 41CMY
Volvo D6-370's
Location: Montreal, Canada
Has thanked: 254 times
Been thanked: 1095 times

Re: Cat, Cum, or Vol ....

Postby Midnightsun » November 23rd, 2016, 9:12 am

I cannot compare as I only know my D6 series Volvos when it comes to diesels.

So far I think they are great.

Impeller change is a piece of cake as well as fuel filters and oil filters. Oil filters are actually self draining so when you remove them, they are empty. Nice design as there is actually a drip bowl and drain hole if there were a drop of oil or 2 that you spill. D series are the only marine diesels with hydraulic lifters so you never need to adjust the valves. Other cool feture it they are self draining so to speak so no winterization is required after haul out. I do not trust this and still run some pink stuff through the system. So far I am quite pleased with the overall setup.

Yes parts are spendy however a little searching goes a long way. Found out Mann makes both the primary and bypass oil filters and instead of $45 each the come to $12 and $17 for the exact same item except the exterior color. Volvo crankcase vent filter is $125, exact same Mann filter is $25.

So far I am quite pleased with the overall setup.
Last edited by Midnightsun on November 24th, 2016, 7:21 am, edited 1 time in total.
Cheers, Hans
2007 Carver 41 CMY
Twin Volvo D6-370's
Montreal, Canada
Midnight Sun I Photos
User avatar

Canada
Lyndon670
Admiral
Admiral
Posts: 657
Joined: July 29th, 2013, 11:35 pm
Vessel Info: 2000 Carver 506
Volvo TAMD74EDC
Location: Georgian Bay
Has thanked: 124 times
Been thanked: 139 times

Re: Cat, Cum, or Vol ....

Postby Lyndon670 » November 23rd, 2016, 7:10 pm

Good to know Hans, I have been using Volvo filters only - I'll check the Volvo numbers agains the Mann ones.

The valve adjustment on the TAMD units is scheduled for the 1000hr service. I am currently at 510 so a bit off for me yet. I do like the self draining filers on the D6 series, I am actually looking at a remote filter bank for my filters. Current setup has 2 filters on their side which is a PITA.
Lyndon,
2000 Carver 506
FOXY JOE
Volvo 7.4TAMD
Queens Cove Marina
Georgian Bay, Ontario
User avatar

Canada
Lyndon670
Admiral
Admiral
Posts: 657
Joined: July 29th, 2013, 11:35 pm
Vessel Info: 2000 Carver 506
Volvo TAMD74EDC
Location: Georgian Bay
Has thanked: 124 times
Been thanked: 139 times

Re: Cat, Cum, or Vol ....

Postby Lyndon670 » November 23rd, 2016, 7:25 pm

As for Hats and Viking, they are using their engines in their "low end" builds


Check your info Tony....

Cats are standard in EVERY Viking....MANNS are optional.

Cats are standard on EVERY Hattaras....other engines are optional.

Customers opt for the optional engines NOT because of a lack of quality, but because of HP and speed. On every optional engine in both the builders models there is a 500hp differential on between the standard CAT and the optioanal units. Viking cutomers want to get out to the canyons first, which means more HP required and therefore bigger engine option.

A 5 min tour around Yachtworld shows loads of 70+ Vikings and Hatts with CATS.

Look at the history of the 3208 CAT diesel - touted by many on the Billfish circuit to be one of the best engines ever.

As Viper said, you cant paint a broad stroke over an entire brand.
Lyndon,
2000 Carver 506
FOXY JOE
Volvo 7.4TAMD
Queens Cove Marina
Georgian Bay, Ontario

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 5803
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 431 times
Been thanked: 1586 times

Re: Cat, Cum, or Vol ....

Postby Viper » November 23rd, 2016, 8:28 pm

Lyndon670 wrote:....the 3208 CAT .....one of the best engines ever.....

+1
User avatar

United States of America
PhilH
Scurvy Dog
Scurvy Dog
Posts: 24
Joined: January 23rd, 2017, 10:43 am
Vessel Info: Carver Californian 45 M/Y, 1990 Cat 3208 diesels
Location: Florida
Has thanked: 5 times
Been thanked: 3 times
Contact:

Re: Cat, Cum, or Vol ....

Postby PhilH » April 21st, 2018, 2:29 am

Just my opinion, but ALL diesel parts are expensive. I think the issues arise cause you have to periodically clean out anything that contacts sea water, which includes engine coolers (heat exchangers) aftercoolers or intercoolers, and trans oil coolers. Computer controls make engines run cleaner and better, but I think it is the cooling issues that cause problems the most, regardless of engine brand. FYI, I have Cat 3208 TA's and all services have involved cooling issues because of salt water usage.

Return to “Diesel Engines/Transmissions”



Who is online

Users browsing this forum: No registered users and 11 guests