Welcome to Carver Yachts Owners Forum
We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com
You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
ZF301 twin sync, one lever
-
- CYO Supporter
- Posts: 19
- Joined: August 7th, 2022, 8:18 pm
- Vessel Info: 2002 Carver 506
Configured as a Soft-Top Bridge with Glass Aft-Deck
Cummins 450C (480hp) ~725 hours - Location: Lake of the Ozarks, MO
- Has thanked: 11 times
- Been thanked: 3 times
- Contact:
ZF301 twin sync, one lever
When I tried the procedure from the manual, a steady beep started and did not quit until I shifted into neutral and pressed the transfer button.
Much later I noticed errors on both trans controllers. Both had to do with no assignment of a master/slave.
Could this be a transmission setup issue, say function A0 not properly set?
Or is it as simple as not starting the master engine first?
The transmission controller, set ups look pretty straight forward but, I do not see a setting for master/slave. I might assume that A0 (processor identification) would indicate that, but there is nothing in the manual that explicitly states it.
2002 506
Return to “Diesel Engines/Transmissions”
Who is online
Users browsing this forum: TruckerTim and 11 guests