Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

00 356, Kohler 7_3E Has mind of its own!

GAS engine, transmission and generator repair and maintenance discussion forum.
User avatar

Topic author United States of America
Mark2000356
Scurvy Dog
Scurvy Dog
Posts: 4
Joined: June 4th, 2020, 7:03 pm
Vessel Info: 2000 356 Aft Cabin
Location: Tulsa, OK
Has thanked: 3 times

00 356, Kohler 7_3E Has mind of its own!

Postby Mark2000356 » June 4th, 2020, 7:27 pm

First post... First Carver owned.

My Kohler generator has mind of its own. Some days it will run from the time we leave slip to the time return 8 hours later. Other days will run for 15 min and shut off. Some days it runs while I’m cruising, some days nope. Some days it will run when cove’d out and you guessed it, some days it will not. Acts this way whether the gas tanks are full and while their low.

Here is what I have done:
Serviced twice with oil changes and filters
New impeller
New spark plugs
New fuel filter

Next I may try a new fuel pump and new sensors. Any thoughts here... seems to be a guessing game at this point.

Thank you in advance!!! - Mark

User avatar

Canada
bud37
Admiral
Admiral
Posts: 4971
Joined: April 23rd, 2015, 10:22 pm
Has thanked: 585 times
Been thanked: 1242 times

Re: 00 356, Kohler 7_3E Has mind of its own!

Postby bud37 » June 4th, 2020, 9:52 pm

Welcome to the forum....my sympathies with the gen.

Have you noticed anything as it shuts down, like surging, or running rough etc or does it just shut off as if you turned it off at the panel ?
FWIW.....The above is just my opinion..... :popcorn:
User avatar

Topic author United States of America
Mark2000356
Scurvy Dog
Scurvy Dog
Posts: 4
Joined: June 4th, 2020, 7:03 pm
Vessel Info: 2000 356 Aft Cabin
Location: Tulsa, OK
Has thanked: 3 times

Re: 00 356, Kohler 7_3E Has mind of its own!

Postby Mark2000356 » June 4th, 2020, 10:02 pm

It just shuts down as if I shut it down at the panel. Sometimes I have a load on it (both ac’s) and sometimes it will shut off even with very little load. :banghead:

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 6069
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 460 times
Been thanked: 1711 times

Re: 00 356, Kohler 7_3E Has mind of its own!

Postby Viper » June 4th, 2020, 10:29 pm

Welcome aboard.

I would be prepared for the next shutdown with a meter to check all the sensors; oil, engine temp, water pressure, exhaust temp if applicable, and some are equipped with a low coolant level sensor.

Some other possibilities are bad/intermittent controller fuse, failing controller breaker, loose engine harness plug or corroded or pulled out pins, intermittent voltage regulator fault, corroded relay pins, loose connection or failing component in the controller.

Oh and check the Start/Stop switch on both the remote panel and the on-board one.

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 6069
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 460 times
Been thanked: 1711 times

Re: 00 356, Kohler 7_3E Has mind of its own!

Postby Viper » June 4th, 2020, 10:54 pm

If all that checks out, ensure the engine systems are working properly such as ignition and fuel delivery, though a sudden shutdown usually eliminates a fuel delivery problem.
User avatar

Canada
bud37
Admiral
Admiral
Posts: 4971
Joined: April 23rd, 2015, 10:22 pm
Has thanked: 585 times
Been thanked: 1242 times

Re: 00 356, Kohler 7_3E Has mind of its own!

Postby bud37 » June 5th, 2020, 7:15 am

Viper has a good list there.......just to add, there is a ground that runs to the case under the engine then to the battery on some of those, check that for clean and tight, also I will also say check the switch.
FWIW.....The above is just my opinion..... :popcorn:
User avatar

Topic author United States of America
Mark2000356
Scurvy Dog
Scurvy Dog
Posts: 4
Joined: June 4th, 2020, 7:03 pm
Vessel Info: 2000 356 Aft Cabin
Location: Tulsa, OK
Has thanked: 3 times

Re: 00 356, Kohler 7_3E Has mind of its own!

Postby Mark2000356 » June 5th, 2020, 9:00 am

Thank you everyone... I’ll be at the boat in a few hours and I’ll be checking on as many of these items as I can. I appreciate the help!
User avatar

United States of America
buster53
Admiral
Admiral
Posts: 1041
Joined: May 12th, 2017, 10:41 am
Vessel Info: 2001, Carver 356
Location: Lower Potomac, VA
Has thanked: 9 times
Been thanked: 262 times

Re: 00 356, Kohler 7_3E Has mind of its own!

Postby buster53 » June 18th, 2020, 2:02 pm

I had a lot of problems with mine and it turned out the anti-siphon valve was the culprit. Replaced it and all is good.
FYI, the valve is right at the top of the fuel tank, I believe, just inside the tank.

Same boat, same genset.

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 6069
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 460 times
Been thanked: 1711 times

Re: 00 356, Kohler 7_3E Has mind of its own!

Postby Viper » June 18th, 2020, 10:42 pm

The anti siphon valve will be one of the fittings where the hose is fastened to the top of the tank on the outside of it. Depending on the build, there may be one or two fittings visible, one will be the anti siphon valve. From the outside though, it'll look just like a regular brass or aluminum fitting.

Return to “Gas Engines/Transmissions”



Who is online

Users browsing this forum: No registered users and 18 guests