Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

1997 Mariner 350 question

The is the forum to discuss general information regarding all Carver Yachts.
User avatar

Topic author
JimnJudi
Scurvy Dog
Scurvy Dog
Posts: 10
Joined: November 28th, 2015, 12:28 pm
Vessel Info: 1997 350 Mariner
Location: Macedonia, Ohio
Has thanked: 1 time
Been thanked: 2 times

1997 Mariner 350 question

Postby JimnJudi » November 28th, 2015, 12:46 pm

Can anyone tell us what electrical fixture is in the cabinet above the fridge in a 1997 Mariner 350? Ours has 2 insulated 12v wires with open ends coming from the ceiling into the cabinet with nothing connected. Any help is appreciated.

Thanks
Jim and Judi

User avatar

After Taxes
Deck Hand
Deck Hand
Posts: 84
Joined: September 21st, 2014, 9:55 am
Vessel Info: 'After Taxes'
2004 Carver Mariner 360
Lake Simcoe & Georgian Bay,
Ontario, Canada
Location: Lake Simcoe Marina
Has thanked: 6 times
Been thanked: 17 times

1997 Mariner 350 question

Postby After Taxes » November 28th, 2015, 4:32 pm

So it appears the original fuxture was removed and the wires simply left exposed? Yea, I've seen stuff like that. Some boat owners are ... something else, aren't they?

Why not use a 12-volt tester, (available at any hardware store, or borrow from your friendly mechanic) determine if you have power, then purchase any 12-volt marine quality fixture of your choice and install. Today's choices are immeasurable over what was originally installed, so you shouldn't need to worry about replacing as original part.

My ceiling fixtures are all small round G4 halogen (which I've the replaced almost all halogen G4 type bulbs with LED - not the fixtures, just the bulbs), however over the galley sink, I have one, approximately 12-inch long florescent fixture.

Trust this helps.

Steve
2004 Carver Mariner 360
MerCruiser MX 6.2
Lake Simcoe, Ontario

Image
User avatar

Topic author
JimnJudi
Scurvy Dog
Scurvy Dog
Posts: 10
Joined: November 28th, 2015, 12:28 pm
Vessel Info: 1997 350 Mariner
Location: Macedonia, Ohio
Has thanked: 1 time
Been thanked: 2 times

1997 Mariner 350 question

Postby JimnJudi » November 29th, 2015, 3:49 am

Thanks For the power suggestion. Is your fixture switched at the light, or is there a wall switch or switch that activates when the cabinet door is opened? I'll test ours next time I'm at the storage building.

Jim
User avatar

United States of America
Ramsport47
Commander
Commander
Posts: 376
Joined: February 10th, 2013, 7:13 am
Vessel Info: 1998 Carver 310 Santego
Has thanked: 72 times
Been thanked: 56 times

1997 Mariner 350 question

Postby Ramsport47 » November 29th, 2015, 6:57 am

I believe that the item in that cabinet was the TV antenna booster. Not sure why anyone would have removed it, unless they took the antenna off as well
Kenny
1998 Carver 310 Santego
T-Merc 350 Mag MPI (300hp)
Port: Cedar Point Marina, Sandusky, Ohio
User avatar

Topic author
JimnJudi
Scurvy Dog
Scurvy Dog
Posts: 10
Joined: November 28th, 2015, 12:28 pm
Vessel Info: 1997 350 Mariner
Location: Macedonia, Ohio
Has thanked: 1 time
Been thanked: 2 times

1997 Mariner 350 question

Postby JimnJudi » December 6th, 2015, 2:18 pm

Good thought Kenny. The dealer put in a garmin digital antenna on the arch before our purchase. If the wires were to an antenna booster, that would explain why there's nothing there now. Does anyone else have a light in the cabinet? Or an antenna booster? Thinking of just permanently capping off in an approved box for safety.
User avatar

United States of America
Ramsport47
Commander
Commander
Posts: 376
Joined: February 10th, 2013, 7:13 am
Vessel Info: 1998 Carver 310 Santego
Has thanked: 72 times
Been thanked: 56 times

1997 Mariner 350 question

Postby Ramsport47 » December 8th, 2015, 5:47 am

Nothing else in that cabinet that I can remember...you should be safe to put butt connectors on the ends of the wires for future use, if needed
Kenny
1998 Carver 310 Santego
T-Merc 350 Mag MPI (300hp)
Port: Cedar Point Marina, Sandusky, Ohio

Return to “Carver Yachts Forum - Model Discussion”



Who is online

Users browsing this forum: No registered users and 23 guests