Page 1 of 1

Can't locate Transducer on Carver 3207 AFT Cabin

Posted: July 5th, 2016, 8:42 pm
by acevesc
Hello,
My Lowrance X70 Depth finder works but the data or reading is wrong. Appears that the distance works but depth indicator doesn't. I was told that the transducer probably needs to be re-adjusted so went in cold water and tried to locate under the boat. Does anyone know where its located?

Connie Acegal
Carver 3207 Aft Cabin | YR 1983
Gas Engine: Twin 350 Crusaders | 6.5 Genset Onan Generator
Home Port: Umatilla, OR

Re: Can't locate Transducer on Carver 3207 AFT Cabin

Posted: July 5th, 2016, 10:24 pm
by Viper
Really depends on where they installed it. Typically they're somewhere in the engine compartment. You should be able to locate it from inside the bilge unless someone installed a transom mounted unit which is not ideal for an inboard application and could be why you're not getting a reading if this happens only while you're underway.

What do you mean by "needs to be re-adjusted"? Unless it's an adjustable angle unit (thru-hull ducer), it will be fixed and can't be adjusted. It may be dirty/fouled, painted over, etc. Are you sure the settings on the display set correctly? What do you mean by distance? Does it have a speed sensor/paddle built into the transducer that calculates distance traveled or are you talking about distance to bottom?