Welcome to Carver Yachts Owners Forum
We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com
You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
QUEST
- tonyiiiafl
- CYO Supporter

- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
QUEST
- km1125
- Admiral

- Posts: 3624
- Joined: February 28th, 2017, 6:04 pm
- Has thanked: 78 times
- Been thanked: 1093 times
Re: QUEST
tonyiiiafl wrote:Source of the post I am installing new bathroom sink faucets. I have the Quest to PEX adapters, if needed. Question, is why and how did QUEST piping get such a bad rap?
It was used in a lot of mobile home and also single and multi-family new construction "way back when" and had been considered the best thing to use, as it was much easier and much cheaper than copper. After a few decades it started to deteriorate and develop cracks and leaks and had to be replaced, but the leaks also caused major structural damage. There was a huge class-action lawsuit and you could get reimbursed for some of the costs of swapping it out if you met certain conditions. Those conditions had to be things like the "plumbing was installed in non-accessible areas" (like a closed-in wall). I actually explored that when I replaced mine, but a boat didn't quality as there were too many access hatches and ways to get to the piping to replace it.
It actually wasn't that hard of a job to replace it all. I put of the project for several years thinking it was going to be a real PITA, but was glad once I actually committed to doing it and whipped right through the project.
- tonyiiiafl
- CYO Supporter

- Posts: 902
- Joined: November 19th, 2015, 4:00 am
- Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
- Location: Cape Cod, MA
- Has thanked: 601 times
- Been thanked: 193 times
Re: QUEST
Return to “AC/Heat, Plumbing & Sanitation”
Who is online
Users browsing this forum: No registered users and 20 guests

