Page 1 of 2

Spiral Stairs

Posted: March 16th, 2014, 1:56 pm
by 1000islands
I have been looking around for spiral stairs that go from the swim platform up to the aft deck on a 3607 without any success. So subsequently decided to have them made by a local metal fabricator at a cost of approximately $2400.

Then I was told about a company in Pennsylvania that will do them for under $1,000.

Has anybody ever heard of/know anything about, Salter Spiral Stairs?

Re: Siral Stairs

Posted: March 16th, 2014, 2:08 pm
by DanM
Take a look at this link. It may be what you are looking for.
http://www.yachtforums.com/forums/carve ... cheap.html

Re: Siral Stairs

Posted: March 17th, 2014, 9:22 am
by eric_b
Here is an example of DIY stairs done to a 3207.

http://www.boatered.com/forum/topic.asp?TOPIC_ID=144725

Re: Siral Stairs

Posted: March 17th, 2014, 10:25 am
by 1000islands
DanM wrote:Take a look at this link. It may be what you are looking for.
http://www.yachtforums.com/forums/carve ... cheap.html



Yes, that is exactly the stairs I am referring.

Re: Siral Stairs

Posted: May 3rd, 2014, 11:23 am
by Cheryl
We just bought stairs for our 1989 36Carver Aft from Salter. The instructions are for installing in a house so we have to figure it out for the boat. At first glance it is looking alot like IKEA directions. First saw them here in a picture and that is why we ordered them. Hoping to find someone on the board that has done the installation already and can offer some tips before we attempt this.

Re: Spiral Stairs

Posted: May 4th, 2014, 9:50 am
by 1000islands
I am going to install mine this week, depending on the weather, so I'll let you know how it went.

Re: Spiral Stairs

Posted: May 4th, 2014, 11:35 am
by Cheryl
Weather permitting we are hoping to go to marina tomorrow. I will share info too.

Re: Spiral Stairs

Posted: May 16th, 2014, 9:14 pm
by Cheryl
The weather in our area hasn't been very co-operative to try to install stairs. Did you have any luck? Looking at the ladder that has to come it looks like we might have to cut it off, the Allen screws have probably never been touched since the boat was manufactured.

Re: Spiral Stairs

Posted: May 25th, 2014, 10:07 pm
by 1000islands
Staircase (1).JPG
Staircase (4).JPG
Staircase (2).JPG
Staircase (3).JPG
I had to cut the s/s to get the ladder off and I had to drill the screws out on the couplings that held it to the hull.....still looks crappy but it will be okay in the long run.

Re: Spiral Stairs

Posted: May 27th, 2014, 8:47 pm
by Cheryl
Where you have bolted it to the top of the boat, are you leaving the gap? Our step is 19" from the back of the boat to the first step. We are trying to come up with a solution to decrease that height.