Page 1 of 1
1987 Carver Mariner Project Boat - galley pole question
Posted: June 12th, 2025, 9:57 am
by lz33w7
Hello friends,
This is my first boat ever. Does anyone know of this is a “support” pole as I’d like to take it out….
IMG_4505.jpeg
Kindly,
v/r,
Stephen
Re: 1987 Carver Mariner Project Boat - galley pole question
Posted: June 12th, 2025, 10:27 am
by bud37
Is there any wiring/cables etc in there ?
Re: 1987 Carver Mariner Project Boat - galley pole question
Posted: June 12th, 2025, 10:33 am
by lz33w7
Not sure about that…
I’ve seen newer boats, but same model without that pole…..
Kindly,
v/r,
Stephen
Re: 1987 Carver Mariner Project Boat - galley pole question
Posted: June 12th, 2025, 12:14 pm
by Cooler
It was an additional support feature to the floor of the bridge. Provided extra strength to support cabinets hanging in galley, as well as where passengers would walk and sit on the bridge. Not 100% necessary, but I wouldn't pull it out, considering the age of the vessel. It's not getting any younger, and you may regret the potential sagging effect. Good luck.
er
Re: 1987 Carver Mariner Project Boat - galley pole question
Posted: June 12th, 2025, 2:21 pm
by waybomb
It is a support pole.
There are no wires in it.
I had to shorten mine when I installed the granite counter tops.
Re: 1987 Carver Mariner Project Boat - galley pole question
Posted: June 12th, 2025, 5:58 pm
by km1125
I would definitely not pull it out. I had three like that in my 3607. I think you'd get a lot of "flex' in the sole of the bridge.