Page 1 of 1
Hello from Ontario
Posted: October 20th, 2020, 5:18 pm
by Mark N
I have just acquired a ( new to me) 88 3207 rear cabin and will be keeping it at Port Stanley on Lake Erie. The boat is in good condition with a few items to be serviced. I was wondering if any of the members might know what size cutlass bearing this craft takes or can point me the right direction to find out.
Nice to be here.
MarkN
Re: Hello from Ontario
Posted: October 20th, 2020, 5:32 pm
by g36
Congratulations and welcome aboard
Re: Hello from Ontario
Posted: October 20th, 2020, 7:00 pm
by tomschauer
I would measure the shaft and strut to be certain.
Info in the build book isn't always correct.
Re: Hello from Ontario
Posted: October 20th, 2020, 8:04 pm
by Viper
Congrats and welcome aboard. I agree with Tom, being this close to haul out anyway, you may as well wait and measure to be sure in case something's been changed by a previous owner.
Re: Hello from Ontario
Posted: October 21st, 2020, 5:53 am
by pepmyster
Welcome!!!!!!!!!!!!!
Re: Hello from Ontario
Posted: October 21st, 2020, 9:14 am
by waybomb
Welcome aboard!
Re: Hello from Ontario
Posted: October 21st, 2020, 12:52 pm
by ColRon
Welcome aboard!
Re: Hello from Ontario
Posted: October 21st, 2020, 9:14 pm
by bud37
Welcome to the forum.
Re: Hello from Ontario
Posted: October 30th, 2020, 10:19 am
by Dolce23
Hey, I was in Ontario and I really liked those areas! That was fantastic.
Anyway, welcome to the forum, you may check my
website if you are interested.