Carver Owners Forum

Posted: **April 12th, 2021, 6:44 pm**

Looking into a Carver and was told there is an 1/8th inch shaft creep on the starboard shaft.

Posted: **April 12th, 2021, 10:06 pm**

Welcome aboard.

What are you referring to as shaft creep? This is usually the term used for a shaft that is turning while the transmission is in neutral. Is this what is happening? If this is what you are referring to, what do you mean by 1/8th inch?

Posted: **April 14th, 2021, 7:56 am**

I'm curious too.

Posted: **April 14th, 2021, 9:12 am**

schooner wrote:Source of the post Looking into a Carver and was told there is an 1/8th inch shaft creep on the starboard shaft.

I wonder if you mean end play....as in the shaft moves for and aft 1/8" ?

Carver Owners Forum

Shaft creep on a 356 2001 carver causes and remedies.

Shaft creep on a 356 2001 carver causes and remedies.

Re: Shaft creep on a 356 2001 carver causes and remedies.

Re: Shaft creep on a 356 2001 carver causes and remedies.

Re: Shaft creep on a 356 2001 carver causes and remedies.