Welcome to Carver Yachts Owners Forum

We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com

You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

Launch (maybe sunk almost?)

Anything related to the operation of your boat. Steering, Bilge Pumps, thru-hulls, bottom paint, etc.
User avatar

Topic author United States of America
tonyiiiafl
CYO Supporter
CYO Supporter
Posts: 902
Joined: November 19th, 2015, 4:00 am
Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
Location: Cape Cod, MA
Has thanked: 601 times
Been thanked: 193 times

Launch (maybe sunk almost?)

Postby tonyiiiafl » April 23rd, 2022, 5:08 am

Never even got the thruster tested or wired up. Another project for next weekend.

Arrived at marina storage yard and she was on the travel lift. Went inside and floors all opened up. So we got settled in and I asked how it started. They said they never commissioned the engines. If I wanted them to I would have to put it in a slip and leave it for a week or so. I had this on my work list for a couple reasons:

An extra set of eyes is always good

In years past, you didn’t need to be present for the launch and they left it at a slip (This year they wanted you there for the launch)

So I had them drop me in the water and started the engines. Started easy and great running. Pumping strong water. The mid bilge pump comes on. Stays in for about 2 minutes. Dock hand said it was a lot of winter water in the bilge. As engines were warming up pump comes on and off a few times and now the aft pump also does the same. I back up off the lift and head towards a slip to check things out. They said it was nothing but I insisted on docking and checking the engines over. Wind blows hard and I go sideways. Saved it and got into the slip. Went below and saw sea water pouring in. Hopped into the bilge and saw the strainer for the genset was open. I mean water was pouring in. So I managed to squeeze myself down there and shut the seacock. Pumps cycled a few more times. We ran engines 20 minutes or so and I was getting lamb basted for the external thruster. So I did something out of character and said “ why don’t you and your tiny *&^%$ go #$### yourself, mind your own business and go fuck
Yourself again and take a long walk off of a short pier? He started rambling and I looked at him again and said “ say all you want but I do not deal with people who are mentally unarmed” Like I said, I have gotten it all ways to Sunday from everything to you are going to kill someone, to did you check with insurance company and everything in between. Yeah, sadly I hit that point.

. We left the slip and headed out to the channel. I gave her some throttle and the bow comes up a bit and the aft pump comes on again. Must have been water flowing back. Then the forward pump comes on. Once out of the channel I investigate and switch is stuck on. New switch they installed. We are now at junction of Cape Cod canal and a piece of the old canvas blows off! Screw it, just gave her more throttle. ((I used my old canvas for winter, store new one at home)) it just kept going. Made it to Taylor’s Point with wind howling but in my favor. Got her slipped. Cut the forward switch wire then had a couple drinks. But it is home and no one sunk or got hurt.

Now to figure out the strainer issue, and commission systems. I guess you could say I saved $260.00 in commissioning fees for the bright side. We move in net weekend.
7B3DAD6E-22E7-454D-8CF9-1D9497A28BF6.jpeg
569B48E4-01B8-462E-AA10-E419BCCB5AD4.jpeg
You do not have the required permissions to view the files attached to this post.

User avatar

Canada
Midnightsun
CYO Supporter
CYO Supporter
Posts: 2982
Joined: March 27th, 2016, 2:27 pm
Vessel Info: The Midnight Sun
2007 41CMY
Volvo D6-370's
Location: Montreal, Canada
Has thanked: 272 times
Been thanked: 1180 times

Re: Launch (maybe sunk almost?)

Postby Midnightsun » April 23rd, 2022, 5:59 am

Glad to hear things worked out for you in the end, could have been pretty bad had you not been vigilant. This is one thing I am always very careful about after winterizing. Everything gets put back together and tightened to spec after winterization. The only exception is the water heater bypass/drain which I do just before spring launch where I also double check all my sea cocks and strainer caps including the raw water pickup strainer for the wash down which is hidden in the rear deck on my boat so not even in the same bilge as all the rest of them.

Went to the Marina yesterday just for the heck of it. All electrical shore power boxes are still covered up and the marina is boarded up which it should be as they do not officially open until May 20th. Also on the way, stopped to see the boat in storage, everything on board looks/smells and feels just like when I left her last fall, no surprises. :down: Starting to prepare for a few planned but unfinished projects I want in before launch. Lithium setup, new holding tank monitor installation, inverter.

-1C this morning and a high of 9 today, slow spring for sure this year.
Cheers, Hans
2007 Carver 41 CMY
Twin Volvo D6-370's
Montreal, Canada
Midnight Sun I Photos
User avatar

Topic author United States of America
tonyiiiafl
CYO Supporter
CYO Supporter
Posts: 902
Joined: November 19th, 2015, 4:00 am
Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
Location: Cape Cod, MA
Has thanked: 601 times
Been thanked: 193 times

Re: Launch (maybe sunk almost?)

Postby tonyiiiafl » April 23rd, 2022, 6:19 am

UGH, OH CANADA! I tell you, if I were that 300lbs I was a few years ago, I never could have gotten down there like I did.

SO, today we commission water systems, heat and A/C. then take a look at that strainer. I am thinking it is just not seated properly.

Then refit the trim on the fridge and replace that forward switch and also update the bilge pump, as it is vintage 1994.

CHEERS my friend!

Canada
Viper
CYO Supporter
CYO Supporter
Posts: 6209
Joined: July 10th, 2015, 9:58 pm
Vessel Info: 1989 Carver 3807 Aft Cabin
Location: Ontario, Canada
Has thanked: 469 times
Been thanked: 1765 times

Re: Launch (maybe sunk almost?)

Postby Viper » April 23rd, 2022, 8:38 am

Well that was a day! Glad it all worked out in the end with no major catastrophe Tony.

Like Hans said, the best practice when winterizing is to leave all systems launch ready. Too many partial sinkings as a result of not doing that. Can't rely on memory 6 months later to put something back together just prior to launch that you took apart during winterizing. If I must leave something apart, I leave a note at the helm or on the cabin door as a reminder to address it before launch.

This is where high water alarms come in handy!
User avatar

Canada
Midnightsun
CYO Supporter
CYO Supporter
Posts: 2982
Joined: March 27th, 2016, 2:27 pm
Vessel Info: The Midnight Sun
2007 41CMY
Volvo D6-370's
Location: Montreal, Canada
Has thanked: 272 times
Been thanked: 1180 times

Re: Launch (maybe sunk almost?)

Postby Midnightsun » April 23rd, 2022, 8:42 am

If I must leave something apart, I leave a note at the helm or on the cabin door as a reminder to address it before launch.


Sometimes simplicity is the best medicine. Will keep a mental note of that one for sure if I remember that is. :down:
Cheers, Hans
2007 Carver 41 CMY
Twin Volvo D6-370's
Montreal, Canada
Midnight Sun I Photos
User avatar

United States of America
km1125
Admiral
Admiral
Posts: 3624
Joined: February 28th, 2017, 6:04 pm
Has thanked: 78 times
Been thanked: 1093 times

Re: Launch (maybe sunk almost?)

Postby km1125 » April 23rd, 2022, 8:51 am

I can't imagine not being there and on the boat for launch. When they drop me in the water, I first check for any water coming in and then verify the engine thru-hull are opened and ready for 'engine start'. Start the engines while still in the slings and let them warm for about 5 min while I go back into the engine room and checkover things (belts and make sure no other water is anywhere it shouldn't be) then quickly check the fwd and aft hatches for any water.

At that point I feel comfortable pulling the boat out of the slings and heading to the slip.
User avatar

Topic author United States of America
tonyiiiafl
CYO Supporter
CYO Supporter
Posts: 902
Joined: November 19th, 2015, 4:00 am
Vessel Info: 1994 Carver 39 Cockpit Motor Yacht
Location: Cape Cod, MA
Has thanked: 601 times
Been thanked: 193 times

Re: Launch (maybe sunk almost?)

Postby tonyiiiafl » April 23rd, 2022, 12:07 pm

Due to Covid last couple years they didn’t want you there. Yes for sure I ran until thermostats opened. Otherwise I am on board bringing systems on line.
User avatar

United States of America
g36
Admiral
Admiral
Posts: 2094
Joined: April 7th, 2014, 6:07 pm
Vessel Info: 1997 Carver 405
Location: Soddy Daisy TN.
Has thanked: 7 times
Been thanked: 646 times

Re: Launch (maybe sunk almost?)

Postby g36 » April 23rd, 2022, 2:54 pm

Such happy day getting the boat in the water turned into a day of panic and freaking out, gotta be thankful you were on board. The days ahead will be better now for you I'm sure.
1997 Carver 405
Crusader xli
The Black Pearl
Soddy Daisy Tn.
User avatar

Netherlands
Phrancus
CYO Supporter
CYO Supporter
Posts: 395
Joined: October 1st, 2020, 10:03 am
Vessel Info: Sold: Carver 26 Command Bridge / 280 sedan 1992.
Location: Netherlands, Europe
Has thanked: 16 times
Been thanked: 136 times
Contact:

Re: Launch (maybe sunk almost?)

Postby Phrancus » April 23rd, 2022, 6:05 pm

Sometimes simplicity is the best medicine. Will keep a mental note of that one for sure if I remember that is. :down:


write a note to remember to write a note.....

winter months melt away when you're back at the boat as if it was yesterday that you put it away for winter. And then you try to check all the individual items you remember that you were going to not forget.....
Last edited by Phrancus on April 25th, 2022, 2:16 am, edited 1 time in total.
Share your Carver experiences, share marine life. Donate when you can but post what your Carver adds to your life too!

United States of America
tomschauer
CYO Supporter
CYO Supporter
Posts: 2323
Joined: March 28th, 2016, 10:52 pm
Vessel Info: 1998 Carver 355
Suspicious Fishes !
2022 Kawasaki 310X
Location: upper chesapeake bay
Has thanked: 326 times
Been thanked: 601 times

Re: Launch (maybe sunk almost?)

Postby tomschauer » April 24th, 2022, 10:34 pm

My marina drops the boats, tows them to your slip and ties them up. So, I always leave my thru hulls closed until I am on the boat just in case, I didn't properly tighten a strainer or something.

Return to “General Repairs & Maintenance”



Who is online

Users browsing this forum: No registered users and 16 guests