Carver Owners Forum

Hi all,

I have a 1996 Carver 3 Mariner and I'm hoping to source a replacement roller assembly for the rear sliding doors into the salon. Any assistance would be greatly appreciated.

Another Canadian! We're ramping up our presence here! Welcome aboard.

I'd try contacting Carver with your hull number. They're usually very helpful. If they don't still have the same hardware they may be using on a later model, they should be able to give you a part number and the supplier information. I can still get a lot of parts for my '89 so give it a shot.

Thanks for your suggestion. I'll give them a try.

On a different boat , but sliding salon doors, some guys had found rollers at hardware stores that they used to replace what they had, maybe a possibility for you......

I guess I got lucky but I found rollers for my last 2 boat doors at Lowes in the storm door section.

throwback2, How did you remove the door to replace the wheels?

U may have adjusting screws for the rollers, I would think u can adjust the rollers all the way up into the door, lift up on the door and pull toward u, it should come out of the track.