Page 1 of 1
Carver 346 or 366
Posted: August 12th, 2017, 2:51 pm
by jostephens
Does anyone know the beam width at or close to the waterline for a 346 or 366, trying to figure out if I can fit into a 13' wide slip. thanks.
Re: Carver 346 or 366
Posted: August 12th, 2017, 11:21 pm
by g36
According to this it's beam is 13'2". seems like it wouldn't be a ton different at the waterline.
https://www.google.com/url?sa=t&source= ... fBRtEqc-hw
Re: Carver 346 or 366
Posted: August 13th, 2017, 4:57 pm
by mjk1040
Going to need a wider slip!
Re: Carver 346 or 366
Posted: August 13th, 2017, 8:51 pm
by bud37
Don't forget about the fenders.
Re: Carver 346 or 366
Posted: August 14th, 2017, 8:40 am
by tomschauer
You will need a running start to put the 366 in a 13" slip.
Re: Carver 346 or 366
Posted: August 15th, 2017, 6:14 am
by Ramsport47
Probably subtract about a foot or so from the max beam to give you waterline beam. The max beam is at the gunnel molding, plus the hull sides narrow as they get near the water.