Carver Owners Forum

Hello working on my 2004 Carver 36 and the engine compartment blowers are not getting power, I have power at the helm switch and cabin panel but no power to the blower motor themselves, I fed 12v with a power probe directly to the motor and the blower worked? So I checked the ground on the bus bar and it's good? So where could be the problem?

Did you check the blower breakers?

Yes, checked and there's voltage

Is there some type of inline fuse or a relay?

If the voltage is coming out of the switch, it's normally a free run right to the blower. Odd for sure. You cannot trace the wire from the switch to the blower?

The wire is identify as F2, there's a F2 tag at the beginning of the wire and at the end, it runs behind the panel down a whole of combined wires down a hole between the panel and the tv and disappears, what do you rec I do?

Since we're assuming the POS side is good an easy thing to do is running a temporary Negative wire to a house or engine battery or known good ground somewhere by the blower and try running the blower

LetGoJones wrote:Source of the post The wire is identify as F2, there's a F2 tag at the beginning of the wire and at the end, it runs behind the panel down a whole of combined wires down a hole between the panel and the tv and disappears, what do you rec I do?

Do you have 4 blowers? If so check out this schematic, section 2....... it seems to show relays and a master ?

https://carveryachts.blob.core.windows. ... 3428v1.pdf

If you have the Mariner with 2 blowers then they seem to be just a switch / breaker then the blower itself.....

Check this out also..... May not apply to you ...but....

.viewtopic.php?f=12&t=1193