Carver Owners Forum

hello fellow santogians. Guy here, in need of finding a teleflex 2 inch engine synchronizer guage for my 1989 3467 santego.

does anyone have one or know where I can get one. the synch guage wires to a module that appears to be 3 or 4 inches wide that go to the tachs.

thanks very much

Guy

Guy, are you needing the gauge, the sync module or both?

Its usually the module, not the guage that fails.

hello colron, and tomschauer

thanks very much for responding. my guage has physically broken. i believe the module still works but will know better when new guage is installed. any help in locating one is greatly appreciated.

stay safe

guy

ColRon wrote:Source of the post Guy, are you needing the gauge, the sync module or both?

hello colron

i responed by group respone to you and tomschauer, buy wasnt sure you were actually going to get it, hence a seperate second response. thanks very much for writing back. my guage has physically broken. the module was working but i guess we will find out once i get a replacement guage installed. any thoughts on locating one is greatly appreciated. stay safe, guy

Guy, check Great Lakes skipper. I doubt you will find one exactly like the one you are replacing, but you should be able to find one that will work . It may be a different brand. Look at the back of yours and comparing to the same connections. Here’s a link. https://www.greatlakesskipper.com/boat- ... onizer?p=2. Good luck, Ron

thanks very much ron

be well

guy

Guy did you have any luck finding the synchronizer module? I am needing 2 for my 96 355 Carver Aft Cabin