Carver Owners Forum

I know I have seen this question before but I cannot locate it. I am looking for the black rubber trim insert that wraps around the the flybridge, above the salon windows, on a Carver 396. Other models used it. Mine, like many, has shrunk leaving gaps. If someone has found a replacement please let me know. Thanks.

I think most of those were done by Taylor Made. Check their site. I was able to find similar pieces for my old 28 voyager to replace the old missing ones. I got enough to replace both again just in case bc it was so cheap. Their customer service was very helpful.

https://www.taylormadeproducts.com/hard ... er-vinyls/

Here you go

I was just looking into this today as I haven't been able to find this profile for the Voyager anywhere. Does yours look like this?450

This is what I used on my 396. I initially tried the 5/8" but it was a little loose and did'nt seal the groove. I installed the 3/4" on a hot day and it worked perfectly.
https://www.ebay.com/itm/331287500106
BLACK RV Trailer Thick Vinyl 3/4" Insert Trim Mold Flexible Screw Cover 24 Ft.
Babette's
(45269)
99.9% positiveSeller's other itemsSeller's other itemsContact seller

US $25.95

Here's a thread I started that might help:

viewtopic.php?f=7&t=7650

Kyle

ck36 wrote:Source of the post I was just looking into this today as I haven't been able to find this profile for the Voyager anywhere. Does yours look like this?450

IMG_7936.jpg

Thanks for this. I will be at the boat this weekend and check. Dan