Welcome to Carver Yachts Owners Forum
We are a boating forum for owners of Carver Yachts to enthusiastically discuss all aspects of Carver Boat ownership. Whether you are looking for your first Carver or currently own one, you are sure to feel at home on CarverYachtOwners.com
You are currently viewing our board as a guest which gives you limited access to view most discussions, articles and access our other FREE features. By joining our free community you will have access to searching the forum topics, post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
Exhaust fumes
- Pha8
- Scurvy Dog
- Posts: 24
- Joined: September 28th, 2024, 1:15 am
- Vessel Info: 2002 Carver 346
- Location: Toronto
- Has thanked: 21 times
- Been thanked: 1 time
Exhaust fumes
- bud37
- Admiral
- Posts: 5020
- Joined: April 23rd, 2015, 10:22 pm
- Has thanked: 590 times
- Been thanked: 1253 times
Re: Exhaust fumes
Not sure what is setting the engine room fume detector off.....be careful here as they ( the detectors ) look for explosives like gasoline fumes so again be very sure you do not have a fuel leak from engine fuel systems or fuel tanks although very high levels of CO are flammable. Check all your exhaust hoses all the way to the hull outlets for muskrat damage, you maybe would have water in the bilge from any leak like that though IMO.
As for the CO.....with the blowers and the engines running you are evacuating a lot of air from the engine room so you maybe getting a loop going that pulls exhaust back in thru the aft from outside with certain wind directions. Again be very careful here as CO can be a silent killer.
Check your engine room vents to be sure the inlet vents are clear and letting in fresh make up air.
It is good you are taking this serious.......good luck and be careful.

- Pha8
- Scurvy Dog
- Posts: 24
- Joined: September 28th, 2024, 1:15 am
- Vessel Info: 2002 Carver 346
- Location: Toronto
- Has thanked: 21 times
- Been thanked: 1 time
Re: Exhaust fumes
The boat is new to me. When I transported the boat 5hrs to its new home, both alarms were going off the whole time. I just replaced both impellers and ran each engine after replacing the impellers and both times, both alarms went off. No smell of gas, but I could smell exhaust fumes in the aft cabin. Blowers going and engine bay floor (Salon floor> 1 panel) open.
- km1125
- Admiral
- Posts: 3546
- Joined: February 28th, 2017, 6:04 pm
- Has thanked: 74 times
- Been thanked: 1063 times
Re: Exhaust fumes
And you can try to run one engine at a time to see if the issue is related only to that engine.
- waybomb
- CYO Moderator
- Posts: 2598
- Joined: February 5th, 2013, 9:24 pm
- Vessel Info: 1995 Boston Whaler Rage15
1987 3697 Carver Mariner
1988 Cougar 46 Kevlar Vee offshore
1969 15' Glasspar / 1967 Johnson Electromatic 85 - Location: Saint Joseph,Mi
- Has thanked: 58 times
- Been thanked: 457 times
Re: Exhaust fumes
Fred
1969 Glaspar Avalon /1967 Johnson Electromatic 85
1987 Carver Mariner
1988 Cougar Kevlar 46' with triple blown 572 ci
1995 Boston Whaler Rage
Past - 1988 2807, 1989 4207 Aft
-
- CYO Supporter
- Posts: 17
- Joined: March 24th, 2023, 3:49 pm
- Vessel Info: 1982 Carver Monterey 2687
260 Mercruiser / Mercruiser Alpha sterndrive
1992 Carver 350 ACMY
454 Crusaders with V-drives - Location: Michigan
- Has thanked: 2 times
- Been thanked: 7 times
Re: Exhaust fumes
- Rocketman
- Deck Hand
- Posts: 81
- Joined: October 26th, 2020, 8:07 am
- Vessel Info: 2009 44 Sojourn w/ Volvo Diesel D6-500 engines and IPS drive system.
- Location: Huntsville, AL
- Been thanked: 22 times
Re: Exhaust fumes
CO monitors are only good for about 10 years.
Check where your exhaust port is at relative to your blower input. I have seen where they are too close to each other and the intake pulls exhaust right back in.
If so, you may need to reverse that one (most boats have multiple blowers) to make it blow out instead of in. You are just trying to ventilate the compartment. One blowing in and one blowing out is sufficient to vent.
Return to “General Repairs & Maintenance”
Who is online
Users browsing this forum: No registered users and 28 guests